Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 3
Registered: ‎03-21-2017

75 E Tec 2007 will not start

Turned key on engien turned over twice then there was a PoP noise. Nothing after turned key off then on no System Check beep only a click noise from engine the tilt still works.

Admiral
Posts: 6,139
Registered: ‎07-14-2011

Re: 75 E Tec 2007 will not start

 

 

You do not have to post duplicate questions  on this site. Please read our respose on your other post that asked the same thing. Thank you.

***************


"There is never just one thing wrong with a boat";
                                                 -- Travis McGee, main character in a book series by John D. McDonald


***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. If you elect to do it yourself, be sure to use caution, common sense, and to observe all safety procedures in the vicinity of gasoline, moving engine parts, high temperature components, heavy items, and electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation or a technique, enlist the services of a factory trained technician.