Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 2
Registered: ‎03-22-2018

Consealed remote contol

Bought used 01 ranger 225 gear shift works but reverse don’t go back very far, not like other boats I owned is it normal
Admiral
Posts: 6,744
Registered: ‎07-14-2011

Re: Consealed remote contol

You will not get full throttle in the reverse shift position.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Mate
Posts: 2
Registered: ‎03-22-2018

Re: Consealed remote contol

Ya I figure but don’t the shifter continue throw past gear? It’s hard to pull back even with out cable hooked. Have to go back and forth then it well go back. Think shifter has problem.
Admiral
Posts: 6,744
Registered: ‎07-14-2011

Re: Consealed remote contol

With that description, it is time to contact a dealer if a visual inpection of the cables and control does not reveal an abnormality.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.