Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 1
Registered: ‎11-11-2015

Propeller Nut size

Hello,

 

I have a G2 250HO and need to remove my propeller in order to get to some fishing line which got wrapped behind the prop. I tried a 1 1/16 and found that to be to small. I dont have any other sockets so I need to buy one, I just want to make sure I get the correct size. I tried looking it up online but couldn't find anything and the manuel doesn't give the nut size . Thanks in advance for the help.

Admiral
Posts: 6,300
Registered: ‎07-14-2011

Re: Propeller Nut size

 

 

The prop nut for a G2 is the same size that has been in use on the V6 Evinrudes for years. It also uses the same cotter pin and stainless steel retainer.  It is 1-1/16"

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.