Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 1
Registered: ‎11-19-2013

evinrude 225 etec

Hi 

I have a 2005 225 etec that wont go over 5000 rpm.

It was overhauled 5 hours ago and may still be in run in mode will that keep it at 5000rpm at w.o.t

Admiral
Posts: 7,054
Registered: ‎07-14-2011

Re: evinrude 225 etec

Your motor should be in the 5600-5800 rpm range at full throttle. As long as you have the correct prop and set-up, then the engine may not be putting out full power either from a fuel problem or a mechanical malfunction. See your dealer for diagnosis.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.