Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 3
Registered: ‎08-01-2017

Assistance with Identification, of new to me outboard, Please!

Hello, 

I ran into the need to re power an older boat and located a motor on the Ole' Interwebs.
I was told the motor was an 89' Johnson 150 Crossflow. While I have no reason to think otherwise I want to be sure for future part ordering reference. One reason I bought this motor over others is the clean appearance, even though it has been repainted, it's not repainted to the original specification. The motor does not have the model/serial plate on the transom clamp, but I am able to locate the welch plug/freeze plug number. the number is R8240917. If anyone could lend a hand in helping me confirm or deny the identity, it would be greatly appreciated. 

Thank you in advance,
Paul

Admiral
Posts: 6,159
Registered: ‎07-14-2011

Re: Assistance with Identification, of new to me outboard, Please!

Can you post pictures of the motor cover decals and of all sides of the powerhead and we will try to narrow things down for you?

***************


"There is never just one thing wrong with a boat";
                                                 -- Travis McGee, main character in a book series by John D. McDonald


***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. If you elect to do it yourself, be sure to use caution, common sense, and to observe all safety procedures in the vicinity of gasoline, moving engine parts, high temperature components, heavy items, and electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation or a technique, enlist the services of a factory trained technician.
Mate
Posts: 3
Registered: ‎08-01-2017

Re: Assistance with Identification, of new to me outboard, Please!

Thanks Bill, 

 

The motor has been painted and I wouldn't think the cowling is orignal.

 

I have confirmed the serial palte is not there.

 

It's a crossflow 60deg v6 with plastic carb bowls, if that helps any.

 

Thanks in advance, Paul

Admiral
Posts: 6,159
Registered: ‎07-14-2011

Re: Assistance with Identification, of new to me outboard, Please!

 

 

 

Model #TE150SLCE  
1989 150 HP crossflow
***************


"There is never just one thing wrong with a boat";
                                                 -- Travis McGee, main character in a book series by John D. McDonald


***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. If you elect to do it yourself, be sure to use caution, common sense, and to observe all safety procedures in the vicinity of gasoline, moving engine parts, high temperature components, heavy items, and electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation or a technique, enlist the services of a factory trained technician.
Mate
Posts: 3
Registered: ‎08-01-2017

Re: Assistance with Identification, of new to me outboard, Please!

Thank you!

That is the information I was looking for!