Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Skipper
Posts: 13
Registered: ‎09-13-2011

I-Command 3.5 inch Gauge/manual printed in 2010. Has there been an update?

I was on one the ETEC forums and i came across a question about the same unit i have. They gave a link to down load a new  corrected manual and a software update that has to be done by the dealer. There was information that i should give to my dealer.  Now i cannot find the link  E175DPXIN  Ser.05238866 is my Motor ID.

larrywitt

Highlighted
Admiral
Posts: 5,726
Registered: ‎07-14-2011

Re: I-Command 3.5 inch Gauge/manual printed in 2010. Has there been an update?

 

 

I-Command Digital Network Guide  http://www.operatorsguides.brp.com/OperatorsGuidesAttachments/OwnersManuals_EJ/attach/Accessories/35...

 

 

I-Command 3.5" Users Guide -  for ver. 2.1 gauge software

http://www.operatorsguides.brp.com/OperatorsGuidesAttachments/OwnersManuals_EJ/attach/Accessories/35...

 

 

***************


"There is never just one thing wrong with a boat";
                                                 -- Travis McGee, main character in a book series by John D. McDonald


***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. If you elect to do it yourself, be sure to use caution, common sense, and to observe all safety procedures in the vicinity of gasoline, moving engine parts, high temperature components, heavy items, and electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation or a technique, enlist the services of a factory trained technician.