Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Skipper
Posts: 4
Registered: ‎05-14-2018
Accepted Solution

Running at 5100 rpms

Hi, I have a new 175 etec with about 3 hours on it. It would only run at 5100 rpms fully loaded or empty, does this have anything to do with the break-in period?

Highlighted
Admiral
Posts: 7,054
Registered: ‎07-14-2011

Re: Running at 5100 rpms

Hi 

You do not have to ask duplicate questions here at E-NATION, once is enough.  Read our response at your other posting. You can delete this one.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.