Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 2
Registered: ‎07-18-2017

135 HO and Ranger VS1780 Prop Question

Good morning All,

 

I have a 2017 Ranger VS1780 with a 135HO Evinrude.

Model # E135HGXAB
Serial # 05475762

  When I first purchased the boat It came with a Cyclone TBX 14 1/8 x 19" Propeller, Part # 763942. The engine was mounted 2 holes from the top. The max rpm with this setup and the load I carry (My wife and I + fishing gear) was 4200rpm and 39mph.  I have since Raised the engine to the highest hole and installed a 3 blade Rebel TBX 15 1/2 x 17" Propeller, Part # 763986.  The setup now sees 4950rpm at 41.5mph. I am looking for some advice on what I should do next to get the engine to the optimum RPM?  It runs great and revs all the way through the rpm range in neutral, as well has a great holeshot and accellerates well to 40mph.

Any advice at all would be appreciated

 

Malisk

Admiral
Posts: 6,159
Registered: ‎07-14-2011

Re: 135 HO and Ranger VS1780 Prop Question

Your rpm is too low and you are lugging the motor which could shorten its life eventually.

 

Keep experimenting with engine height and propellers. It is trial and error but your Ranger dealer should be knowledgeable in prop choice.

 

You want to turn the engine close to the midrange for best all around performance, close to 5500 rpm trimmed correctly for best speed. Rebel 15" or a Viper 17" depending on whether you are looking for top speed, cruising fuel economy and acceleration.

***************


"There is never just one thing wrong with a boat";
                                                 -- Travis McGee, main character in a book series by John D. McDonald


***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. If you elect to do it yourself, be sure to use caution, common sense, and to observe all safety procedures in the vicinity of gasoline, moving engine parts, high temperature components, heavy items, and electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation or a technique, enlist the services of a factory trained technician.
Highlighted
Mate
Posts: 2
Registered: ‎07-18-2017

Re: 135 HO and Ranger VS1780 Prop Question

Thanks for the reply!

I will call my dealer and see if I can switch again to the 15" Rebel.