Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Skipper
Posts: 2
Registered: ‎10-31-2013

Trolling 115 E Tec

Hello new here,

 

i have a 2016 115 E Tec--how many hours do i need on it before i can troll with it--Salmon fishing on Michigan--THANK YOU

Highlighted
Admiral
Posts: 6,035
Registered: ‎07-14-2011

Re: Trolling 115 E Tec

 

 

According to the operator's guide, there is no break in needed on an E-TEC. Many people do run their new E-TEC a few hours at varying speeds because they grew up with motors that did need a bit of time to get the rings seated and the moving parts broken in.

 

The choice is yours.

***************


"There is never just one thing wrong with a boat";
                                                 -- Travis McGee, main character in a book series by John D. McDonald


***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. If you elect to do it yourself, be sure to use caution, common sense, and to observe all safety procedures in the vicinity of gasoline, moving engine parts, high temperature components, heavy items, and electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation or a technique, enlist the services of a factory trained technician.