Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Skipper
Posts: 6
Registered: ‎01-10-2017

prop recommendation

I own a Triton 189 TRX with an E-Tec 150 H.O. mounted on a 6" Atlas hydraulic jack plate with a Raker H.O. 14 1/2 X 22 prop. Runs just over 60 gps WOT at 6000 rpm's. Looking for a recommendation on a 4 blade prop as well for this setup. Thanks.

Admiral
Posts: 5,733
Registered: ‎07-14-2011

Re: prop recommendation

 

 

You may want to try the new RX4 prop with its adjustable vents and propping  your motor for around 5500-5800 may also improve top end performance. Everything is trial and error

***************


"There is never just one thing wrong with a boat";
                                                 -- Travis McGee, main character in a book series by John D. McDonald


***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. If you elect to do it yourself, be sure to use caution, common sense, and to observe all safety procedures in the vicinity of gasoline, moving engine parts, high temperature components, heavy items, and electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation or a technique, enlist the services of a factory trained technician.