Thanks for the info. Just saved me a bunch. Tilt/trim would not work so after checking everything else followed these instructions and opened the PDP. Found out the one terminal going to the motor plug had no solder on it and had come loose. Soldered that tight and fixed two other spots with very little solder. Now everthing works great! Just work arround the edge of the cover with an exacto knife until you find a weak area then work the rest loose. The sticky stuff coating the inside is very messy so be carefull!
It's good to hear that you solved the problem.
"There is never just one thing wrong with a boat";
-- Travis McGee, main character in a book series by John D. McDonald
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.
The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.