Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 1
Registered: ‎08-05-2015

ETec oil selection

I recently bought a 25' Aquasport Walk with a 2013 225 ETec which was set for TCW3 outboard oil. I had the dealer set the engine for XD100. Is there any problem running this oil after the motor may have been on TCW3 for over 400 hours?

Highlighted
Admiral
Posts: 6,227
Registered: ‎07-14-2011

Re: ETec oil selection

 

 

Is this a single engine rig and is the engine a 225 HO ? What is the engine model number?

***************


"There is never just one thing wrong with a boat";
                                                 -- Travis McGee, main character in a book series by John D. McDonald


***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. If you elect to do it yourself, be sure to use caution, common sense, and to observe all safety procedures in the vicinity of gasoline, moving engine parts, high temperature components, heavy items, and electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation or a technique, enlist the services of a factory trained technician.