Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Captain
Posts: 44
Registered: ‎03-29-2017

2017 Evinrude etec G2 300hp default code 136

I went out on boat this morning around 8:30am. Water in intercostal was close to flat at start of day. Started out with only 9 hours long on engine from first to outings since Boat was delivered. I added 2.0hrs today. I had 2- engine fault shutdown warnings today. They happened about 1-hour between both events. Speed at time of both events was 28 mph, engine temp at both events was 154 degrees, rpm both times 4250. Engine shutdown default code 136.
That's where I ran the engine the whole time I was out. Both times I put engine in neutral, turn ignition off for 10-15 seconds. Restarted engine. Code disappeared. Engine temp read 140degrees. Rpm at idle .500 . Both times engine operation went back to normal. After the 2 shutdown I went back to Marina and called a day.
Admiral
Posts: 6,228
Registered: ‎07-14-2011

Re: 2017 Evinrude etec G2 300hp default code 136

 

 

Please refer to our response in the OWNER'S ZONE

***************


"There is never just one thing wrong with a boat";
                                                 -- Travis McGee, main character in a book series by John D. McDonald


***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. If you elect to do it yourself, be sure to use caution, common sense, and to observe all safety procedures in the vicinity of gasoline, moving engine parts, high temperature components, heavy items, and electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation or a technique, enlist the services of a factory trained technician.