Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Mate
Posts: 1
Registered: 3 weeks ago

2006 225 etec engine volume

I am a prospective buyer of a 2006 Stanley Pulsecraft that is outfitted with a 2006 225 Etec with 760 hrs on it. I have read about overheat issues and cold start issues with these engines and I have also been warned about volume vs a 4 stroke. I would like to hear feedback from owners on these issues. I currently own and operate an I/O as a work boat and engine volume is my main complaint.
Highlighted
Captain
Posts: 715
Registered: ‎08-20-2017

Re: 2006 225 etec engine volume

Is your reference to volume asking about cubic inch or liter displacement?
Highlighted
Admiral
Posts: 8,624
Registered: ‎07-14-2011

Re: 2006 225 etec engine volume

 

 

You can also go to the www.etecownersgroup.com to converse with numerous E-TEC owners, dealers, and technicians.

 

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.