Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 1
Registered: ‎04-11-2016

2015 etec 60hp. water gauge

Can I fit a water pressure gauge to this motor if so , were do I take pressure line from.

Admiral
Posts: 8,338
Registered: ‎07-14-2011

Re: 2015 etec 60hp. water gauge

There is a brass plug near the top of the block on the stb. side for the water pressure hose fitting.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Skipper
Posts: 7
Registered: ‎03-06-2016

Re: 2015 etec 60hp. water gauge

Is it the same for an e-tec 25?  what should the gauge read? I am considering installing one if I can find a spot.

Admiral
Posts: 8,338
Registered: ‎07-14-2011

Re: 2015 etec 60hp. water gauge

 

 

There is no water pressure  fitting on an E-TEC  25 HP

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.