Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Posts: 3
Registered: ‎03-21-2017

75 E Tec 2007 will not start

Turned key on engien turned over twice then there was a PoP noise. Nothing after turned key off then on no System Check beep only a click noise from engine the tilt still works.

Posts: 7,099
Registered: ‎07-14-2011

Re: 75 E Tec 2007 will not start



You do not have to post duplicate questions  on this site. Please read our respose on your other post that asked the same thing. Thank you.




"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 



The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.