08-31-2016 04:58
I'm due early next spring for my first service on my e-Tec . It's a 50 hp. Was wondering what the average cost and time it takes to do it. Closest dealer is an hour and a half away so I will be waiting for it. Thanks
08-31-2016 05:42
08-31-2016 05:51
Who do you go to ? I live in the Pittsburgh area and was looking at a dealer in West Virginia but I see there is one in new Kensington pa.. Don't know anything about either dealer. Any help is appreciated.
09-01-2016 06:57 - edited 09-01-2016 06:58
We cannot give a price as dealers have different hourly charges and some may have a flat-rate special for the 3 year/300hr. service.
Depending on the engine condition and running environment, here is a list of common parts used in a typical routine service for a 40 throught 60 HP E-TEC. If in saltwater, there may be anodes and additional parts and labor needed. Don't forget to add gear oil, grease, shop supplies, environmental costs, etc. It is always best to talk to the dealer first for a rough estimate or an explanation of parts and what is performed.
2 Champion spark plugs
1 5005440 Thermo
1 339044 Gasket
1 331188 Oring
1 5007335 Fuel filter
1 5006511 Water pump kit
2 311598 Drain screw washer
1 314502 Cotter pin
1 354190 VST filter
5 348839 clamp
5 320107 tie strap
"There is never just one thing wrong with a boat";
-- Travis McGee, main character in a book series by John D. McDonald
***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.
The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.
09-01-2016 08:59
09-01-2016 09:00