Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 1
Registered: a month ago

Moter Dies

I have a 2016 g2 250 HP Evenrude that dies at random times with no codes going off. Does anybody have any suggestions?

Admiral
Posts: 7,342
Registered: ‎07-14-2011

Re: Moter Dies

It could be either a fuel or electrical malfunction and that is what troubleshooting entails - determining which system is at fault and narrowing it down to the individual component(s).

The crankshaft position sensor - CPS - is one item that can shut a motor off instantly and not generate an error code, as can a plugged gas tank vent, or a malfunctioning emergency stop circuit,

A dealer with the appropriate test equipment and trained technician would be recommended your best choice

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Admiral
Posts: 7,342
Registered: ‎07-14-2011

Re: Moter Dies

If your motor is within its warranty period. you will need to contact your dealer for service.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Highlighted
Skipper
Posts: 10
Registered: ‎12-22-2017

Re: Moter Dies

I have exactly the same problem. You're not alone.

 

For me it occurs at low revs when I’m manoeuvring to dock or slide into the lift.

 

It simply cuts out! It will start again however when in close proximity of fixed objects (dock, other boats, etc.) losing power is serious.

 

Evenrude – what’s going on?