Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 1
Registered: ‎07-20-2019

Speedometer hose shooting water

Hi new to e-nation. Repowered my 1976 Grady Hatteras 204 center console w the E-tec 115. Couldnt ask for a better running engine. Odd thing happened last time out i noticed water coming out of the Mesh that contains the binacle and battery wires and all of that. I had no idea there was a speedo hose in there until i cut open mesh to see where the hell water was coming from. I called Mariner that did my repower and one person said a hose must of popped off engine, and another guy got on phone and said plug the hose on lower unit as i do not have a speedometer. Has anyone had this or know of this issue? thx any info be helpfull! Dennis Plymouth Ma.

Captain
Posts: 125
Registered: ‎07-10-2017

Re: Speedometer hose shooting water

Analog speedo gauges use water pressure from the motor to the gauge on the dash.  When analog gauges are removed, the hose is detached.  In your case, it was re-attached to your new motor and why water was spraying under your dash.  Disconnect the hose on the motor and plug or cap it.  Done.

2017 Tidewater 1910 Baymax
Evinrude 150HO (M: E150HGXABH S/N: 05500627H MFDate: 6/17)
Highlighted
Admiral
Posts: 8,402
Registered: ‎07-14-2011

Re: Speedometer hose shooting water

 

 

Trace the hose back to the motor to see where it is attached. It is possible that it could also be for a water pressure gauge that was not hooked up on your boat or the hose never plugged during rigging.

 

If it is a speedometer hose, it will attach to front upper part of the lower unit and you can obtain a rubber cap and tie-rap for the fitting.

If it goes to the engine block, it was for a pressure gauge and is best to remove the fitting and install a brass plug in its place.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.