Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Posts: 2
Registered: ‎05-21-2016

2007 115 etec noise

i have a 115 that is emitting a howling noise at idle. tae boat is at the dealer now and he is not sure.listen to the viseo and if you reconize this , please help .it is not a continuious noise. noise shows up at idle after a run at mide rpm.

Posts: 8,832
Registered: ‎07-14-2011

Re: 2007 115 etec noise

[ Edited ]

Noises can be from almost any rotating part. Inspect the flywheel and check the gearcase for obvious causes and have a factory trained E-TEC technician examine the engine for the noise. 




"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 



The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.