Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Mate
Posts: 2
Registered: a week ago

2013 200 Evinrude starting problem

When I turn the key nothing happens. No lights or gauges come on. No self check. Batteries are good and I’ve checked every fuse I can find after much research. It has a perko aftermarket wire harness so I can’t even replace just the switch. Someone help !!! I’ve checked everything I can think of
Highlighted
Captain
Posts: 157
Registered: ‎10-21-2015

Re: 2013 200 Evinrude starting problem

Get a copy of the MWS wiring diagram so you can better understand the circuitry.  At keyswitch, there should be battery voltage present between ground and the red/purple wire.  When keyswitch is turned to run position, battery voltage should then be present between purple lead and ground.

ElderSparky



· Was your question answered? Help others find the answer by clicking "Accept as Solution".
· See a great post? Give a Kudo kudo.pngto show your appreciation!
Highlighted
Mate
Posts: 2
Registered: a week ago

Re: 2013 200 Evinrude starting problem

No power to trim on the throttle either
Highlighted
Captain
Posts: 813
Registered: ‎08-20-2017

Re: 2013 200 Evinrude starting problem

Did your fuse checks include the 10 amp fuse on the engine?