My brand new 2020 e-tec 30 hp manual start will once in a while go into safe mode.
No red leds. Electronics-module not hot at all. Oil is full to the top. water ifrom the pilot-outlet is splashing out normally. Any clues as to what is the problem ?
Thanks for suggestion, but I am dead sure that motor was started at dead idle in these cases.
Wll send to service agent, but have read on the forum than error codes are not always shown via
diagnistics. If so, I am probalby in deep trouble, Or what ?
Thanks for info. When the engine "goes into safe mode", I could stop and restart without any problems and engine
then runs at full speed. Once however, it was just neccessary to let it run at idle for some minutes, then give full
throttle, and it was running fine again (meaning stop/restert was not neccessary).