Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Skipper
Posts: 18
Registered: ‎07-08-2019
Accepted Solution

Missing ID plate

[ Edited ]

Looking for definitive model number for motor before your site shuts down. Looks like G04249107. Engine.jpg.

  Problem is determining between 1995 and 1996. It does have a red plud BUT it was spliced in to be able to hook up to a 1985 control box, The picture I will include shows newer harness from motor with spliced in RED PLUG  on left with it hooked up to 1985 control box. He ran it like this  ( except with red plugs together ) without Tach or Trim guages. My problem PLEASE is finding out which year it is as right now it is sitting on fence between 2 years for finding proper shop manual. Hoping between serial number from silver plate on motor OR a look at wiring harness from motor that someone could narrow it down for me. New on left old on right.jpg

Highlighted
Admiral
Posts: 9,223
Registered: ‎07-14-2011

Re: Missing ID plate

Got any white stickers on the carbs with numbers on them?

 

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Highlighted
Skipper
Posts: 18
Registered: ‎07-08-2019

Re: Missing ID plate

BluewaterBill  Thanks for trying to narrow it down for me. Went out and checked and the white stickers on the carbs are blank. Here are the pics in case it helps. 20200730_084131.jpg20200730_084138.jpg20200730_084149.jpg20200730_084155.jpg20200730_084319.jpg20200730_084358.jpgI chose small for pics but could choose higher if needed. THAMKS again for help.

Highlighted
Admiral
Posts: 9,223
Registered: ‎07-14-2011

Re: Missing ID plate

 

 

Finally heard back

 

G04249107 = J115SXEU  1997

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.