Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Cg6
Mate
Posts: 1
Registered: ‎03-30-2019

Using single g2 without DPS

Looking for a little help here. I recently purchased a used 2016 g2 225ho counter rotation motor to use as a single for my 20’ fiberglass Starcraft. The mechanic was mounting the motor and noticed it lacked the Dynamic Power Steering. The motor was originally purchased as a twin. He contacted evinrude but I haven’t heard back.

If anyone could help answer the following questions, it would be greatly appreciated.

Can I run it without DPS?

What would be the affects of not having dps?

Can I add DPS? Cost?

Highlighted
Admiral
Posts: 8,274
Registered: ‎07-14-2011

Re: Using single g2 without DPS

What is the model and serial number of the motor?

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Captain
Posts: 532
Registered: ‎08-20-2017

Re: Using single g2 without DPS

Counter rotation engines we're not manufactured with DPS. They are designed to be installed in twin engine applications where the standard rotation engine has DPS and steers the CR engine through a mechanical tie bar. On catamaran hulls a "liquid tie bar" is used which uses hydraulic hoses to link the two engines.
There is one integrated hydraulic (non-DPS) standard rotation engine produced for the bass boat market presumably to give a stiffer steering feel at high speed.
As a tech I have not seen anything published by Evinrude about connecting the hoses of a standard hydraulic helm directly to a CR engine. Since a CR engine can be steered through a liquid tie bar one can assume that you could connect standard hydraulic hoses and have standard steering.