Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Posts: 1
Registered: ‎07-07-2017

2017 200 e tec ho

Just got 2017 triton trx 18 with a 200 etec ho with 25p raker prop and gets on plane fast but I only get 60 mph at 5000 rpm at wot. thought I would get alot more speed. this was by myself light gear 30 gal of gas

Posts: 8,870
Registered: ‎07-14-2011

Re: 2017 200 e tec ho





Year designations have not been used by outboard motor manufacturers since before or at 2012.


What is your full engine model number as printed on the serial number sticker?


No matter which type of 200 HO that you have, the top rpm is too low.  It may be the setup, the engine, overpropped, or an adjustment. First you need a knowledgeable technician to check over the engine mounting height, cable adjustments if applicable, and to make sure the engine is delivering full power. If everything checks out OK, you can experiment with propellers. Your engine need to deliver a top rpm in the optimal range determined by Evinrude for best all around performance and economy. The optimal range is a narrower rpm band that the whole operational range.





"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 



The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.