Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Skipper
Posts: 14
Registered: ‎08-29-2014

Re: 135 HO Overheat alarm

This goes back some time to my first post on my overheat alarm. I finally left it with Rockport Marine and they solved the problem. It was the pressure regulator spring-too much tension. The replaced the spring and all is well. 

Admiral
Posts: 8,496
Registered: ‎07-14-2011

Re: 135 HO Overheat alarm

[ Edited ]

 

 

It is good to hear that it was a simple fix

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.