My newly-acquired bass boat drains LOTS of water from the drain plug after I I pull her out of the lake. Also did this after a good rain sitting in the driveway. In the first case (after a day of boating) there was no water in the battery/gas tank compartment where the bilge pumps are located. In the second case (heavy rain), there was water at the bottom of the battery/gas compartment. I have never looked under the compartments/platforms, but I assume there is an additional enclosed area under the battery/gas tank comparment? How do I get to this? How does water normally get pumped out from there if it's located under the bilge pumps in the battery/gas tank compartment?
My newly-acquired bass boat drains LOTS of water from the drain plug after I pull her out of the lake. Also did this after a good rain sitting in the driveway.
Contact your dealer and ask to have an automatic bilge pump switch installed if your boat does not have one or repair it if it does.
Find out where the water is entering the boat when in use and correct that situation too.
Keep the drain plug out when the boat is not in the water and place a tag on the steering wheel to remind you to install it before launching the boat.
"There is never just one thing wrong with a boat";
-- Travis McGee, main character in a book series by John D. McDonald
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.
The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.