Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Skipper
Posts: 5
Registered: ‎02-27-2019

1999 Evinrude E175FPXEE No oil light, Check engine light and hot temp light

Good Morning,

 

So after starting up my Evinrude E175FPXEE and running it for about 20-30 min the check engine light will come on and shut the motor off.  Then all 3 lights come on(no oil, check engine and hot temp).  If i try to restart i get nothing as if the battery were dead.  About 20-30 min of letting it cool and will start right back up no problem.  I have checked to make sure its peeing.  I replace the water pump/ impellar and also made sure water is circulating through the ECU.  I also check the thermostats and found out it has none and its ran a long time without them.  Im not sure if the ecu has gone bad or not. 

Unfortunately i dont has ready access to a boat mechanic with diagnostic software due to being stationed in Guantanamo Bay, Cuba.  Any suggestions?  

 

I do know i need to get some thermostats ASAP!

 

Thanks,

Nick

Admiral
Posts: 8,427
Registered: ‎07-14-2011

Re: 1999 Evinrude E175FPXEE No oil light, Check engine light and hot temp light

 

 

3 of the 4 lights coming on ( low oil is not lit as its circuit is not through the ECU) means there is a problem inside the ECU. There are several repair companies that rebuild the electronics. They are not part of Evinrude and are not associated with the factory in any way.

FICHT ECU & EMM Repair
http://www.cdielectronics.com/ficht/ Call 1.800.467.3371 
marinecomputersupply.com
dfitechnologies.com
http://fichtemmrepair.com/#home

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Highlighted
Skipper
Posts: 5
Registered: ‎02-27-2019

Re: 1999 Evinrude E175FPXEE No oil light, Check engine light and hot temp light

Thats what i was afraid of!! Thanks again for your help!!