Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 3
Registered: ‎03-05-2012
Accepted Solution

200 HP E-tech top speed

Just bought a 21' Ranger Reata with a 200HP e-tech HO on it. Run great but hear is the question. We are about 3500' in elevation and the boat runs about 47 MPH wide open at ~~5400 RPM. Will this speed increase once the motor is broke in?? If so, ~~ what is the break in time on this motor?

 

Thanks

Highlighted
Admiral
Posts: 8,424
Registered: ‎07-14-2011

Re: 200 HP E-tech top speed

[ Edited ]

The optimum rpm for that motor is in the 5500-5700 range for all around performance. Due to the thinner air at your elevation, your motor will not put out the same hp as it will at sea level. Temperature makes a difference also.

 

Your local dealer should be familiar with performance and setup for your rig in your location. You can play with engine heights and different props to get the rpms up a bit and into the recommended range.

 

There is no break in on the motor that you have to worry about. It will add extra oil above 2000 rpm for the first 2 hours and you can run the motor the way you want.

 

 

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.