Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Posts: 1
Registered: ‎03-01-2019

2005 Etec 90 Warning lights

While about 30 mins into my trip up the river I hear a short beep and notice the no oil and water temp lights illuminate for a sec. I immediately turned off the engine and checked under the cowl. On my return down the river I notice a short beep followed by the no oil , water temp and check engine light illuminate for a sec. Shortly after that I ran out of gas. These warning lights wouldnt have anything to do with low fuel , right?

Posts: 951
Registered: ‎08-20-2017

Re: 2005 Etec 90 Warning lights

Running out of fuel in your tank would not trigger those lights. Possibly a system check gauge problem but you should have it checked for any stored codes.
Posts: 9,593
Registered: ‎07-14-2011

Re: 2005 Etec 90 Warning lights

[ Edited ]



With the three lights coming on (LOW OIL stays unlit) it may mean that there is an anomaly inside the EMM, probably an intermittent problem often related to the temperature of an electronic component after running for a while. Your dealer might want to download an engine history report to see if there are any stored service codes or abnormal indications.


It is an electrical situation, not fuel related, but is some circumstances the EMM problem could make the engine stop and mimic an out of gas situation.





"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 



The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.