Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Mate
Posts: 1
Registered: 3 weeks ago

2007 90hp etec oil to fuel check valve

Purchased a 90 hp etec, missing the fuel to oil incoming Tee fitting. Looked in manual can't find good picture or routing of hose. Thanks if anybody has a picture or diagram.
Highlighted
Admiral
Posts: 9,387
Registered: ‎07-14-2011

Re: 2007 90hp etec oil to fuel check valve

 

 

 

0345701 FITTING. Oil check valve to fuel inlet tee

 

0348838 CLAMP, Oil Hose to fuel tee - (10.5mm)

 

2 required -  

0346150 HOSE CLAMP,  FUEL LINE 18.5mm

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Highlighted
Captain
Posts: 930
Registered: ‎08-20-2017

Re: 2007 90hp etec oil to fuel check valve

You may have an 08 model engine that was made in late 07. The newer engines did not have the oil T in the fuel line.
Highlighted
Admiral
Posts: 9,387
Registered: ‎07-14-2011

Re: 2007 90hp etec oil to fuel check valve

 

 

Rick brings up a good point and I was lax in my quest for detemining the correct engine. 

 

Normally we do not give out specs or part numbers unless the model number of the motor in question is posted.

 

Do not order any of the part numbers I previously posted until you give us the engine's model number and we determine if those parts apply.

 

 

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.