Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Skipper
Posts: 6
Registered: ‎03-17-2017

2013- E175DPXABA, warning lamps

I have a 2013, 115 that shows no fault codes in the EMM and history shows none also. The system starts up when you turn the key on and the gauge does the system check "lights 4-3-2-1 on then off in about 3 seconds. 2 seconds later the "no oil", "low oil", and "ck engine" lamps come on. The dealer told me to replace the gauge. I did and no change. Since there is NO support from Evanrude, the 2 local dealers have no further answers. The other odd thing is, the tach also is not working. Continuity is good in the harness to the gauge from the engine. The engine runs normal on test runs and again, the diagnostics from the EMM have no faults codes at all. Any advise would help.
Admiral
Posts: 8,435
Registered: ‎07-14-2011

Re: 2013- E175DPXABA, warning lamps

Dudster,

 

We already answered this same question that you asked here yesterday.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Skipper
Posts: 6
Registered: ‎03-17-2017

Re: 2013- E175DPXABA, warning lamps

Where, Bluewater Bill?
Highlighted
Admiral
Posts: 8,435
Registered: ‎07-14-2011

Re: 2013- E175DPXABA, warning lamps


@Dudster wrote:
Where, Bluewater Bill?

 

 

 

http://community.evinrude.com/t5/Owner-s-Zone/No-oil-alarm/m-p/29922#M10443

 

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.