Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 4
Registered: ‎07-14-2019

225hp E225DXPAB Fuse location for tilt

Lost power to tilt trim
Try to lower trim while boat in motion now lost power
Admiral
Posts: 8,430
Registered: ‎07-14-2011

Re: 225hp E225DXPAB Fuse location for tilt

 

 

The nice thing about this site is that you do not have to ask the same question more than once. It has already been answered in your other posting.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Mate
Posts: 4
Registered: ‎07-14-2019

Re: 225hp E225DXPAB Fuse location for tilt

The question was is there a separate fuse and the motor compartment for the tilt trim answer should be yes or no