Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Captain
Posts: 26
Registered: ‎02-26-2013

60 e-tech DTLAAA

Is it normal for the centre section of my bottom end above cavitation plate to be rough and a different color. brand new only seen water yesterday for prop choice setup. Thanks

 

 

 

Highlighted
Admiral
Posts: 9,221
Registered: ‎07-14-2011

Re: 60 e-tech DTLAAA

That is the normal finish on those motors. The leg is a lost-foam cast item, thus the texture from the foam pattern, compared to a die-cast piece that usually has a smooth texture. 

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.