Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Skipper
Posts: 11
Registered: ‎08-25-2017

Brand new 90 etec keeps quiting

Bought a new 90 etec in May of this yr 2017, we ran it for about a month and a half and it quit on me just like it ran out of fuel. Took it to the dealer and after 2 weeks of being there and taking everything apart they said they found a bad clamp on the fuel line but the mechanic told me he even hooked it to a different tank and hand pumped the fuel in it and it still wouldn't start. When they finally got it going I ran it may 6 or 7 trips on the river and it did the exact same thing. This time they said that It was a kink in the fuel line, then after about 2 days they now want to bill me $1300 because they said I used bad fuel and they would not warranty any problems. Needless to say I will be looking at putting something different on the back of my boat next summer.
Highlighted
Admiral
Posts: 8,844
Registered: ‎07-14-2011

Re: Brand new 90 etec keeps quiting

You may want to email your story to  brp.care@brp.com  with the engine serial number, dealer name, and your contact information.  They will look into it.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.