07-27-2017 04:13 - edited 07-28-2017 06:49
Cdi instructions say disconnect all safety circuits and clipper circuits then remove them. So how's th battery charge the tech work?
How's the battery charge and the tech work? Thanks guys, I removed the clipper circuit only then installed the pulse pack. The motor fired as long as the starter was engaged but died when key turned back to run position. After studying the schematic I realised taking the clipper circuit out broke the rectifier circuit so I made a jumper to connect the rectifier to keyed power and that old motor ran like a spotted ape! Going fishing in the morning!
Evinrude does not recommend removing any safety devices.
"There is never just one thing wrong with a boat";
-- Travis McGee, main character in a book series by John D. McDonald
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.
The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.