Need help locating a [manufacture/part number] skeg protector for a 2003 Evinrude 225 H.O. Bombardier FICHT engine.
Tip of the skeg recently broke off and my engine type is not listed on the Megaware (keelguard) web site, and I've spoken with the folk at Skeggard, and because of something to do with cavitations issues they don't provide products for High Output engines.
Any help would be appreciated.
03-21-2012 05:35 - edited 03-21-2012 05:43
You might want to talk with a knowledgeable propeller shop to see about welding a piece of aluminum and reshaping it for your skeg. A regular welder may not be experienced with the type of aluminum alloy used in outboards and could produce a rough looking and weak weld.
Replacement skeg pieces that can be reshaped are available from
If it is just a small area that is broken, it can sometimes be smoothed over and reshaped with a grinder.
"There is never just one thing wrong with a boat";
-- Travis McGee, main character in a book series by John D. McDonald
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.
The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.