Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Mate
Posts: 1
Registered: ‎08-17-2019

ETEC on NMEA

Hello everyone,, I purchased a 15ETEC HO this past spring for trolling lake Michigan. I have a Humminbird Helix10 which will display my 200G2 information. This unit supports a second motor and I would like to get my 15 Kicker motor on this display; however, the ETEC 15 does not natively sit on NMEA. I"m seeking a recommendation to convert the analog signals for RPM's to NMEA so I can display on my Helix10. Any help would be appreciated.... Thanks,
Highlighted
Admiral
Posts: 9,460
Registered: ‎07-14-2011

Re: ETEC on NMEA

 

 

Sorry to say but there is no NMEA2000 output on the 15HO or other engines smaller than 40 HP.

Evinrude does not make any type of adapter and does not recommend any aftermarket add-ons to electrical, ignition, or EMM components.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.