Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Skipper
Posts: 8
Registered: ‎09-29-2012

Re: Engine sound

Thanks Bill. The ventilaton plate is just visible at cruise speed so the engines is mounted correctly. I'll keep trying props to see if I can solve the problem. Thanks.

Admiral
Posts: 8,402
Registered: ‎07-14-2011

Re: Engine sound

 

 

Here are several different props with Evinrude part numbers that you should try. Remember that finding the best all around propeller is always trial and error, no two boats are always alike.

 

763957  13" pitch  SSP 3- blade

 

763950  15" pitch  SSP 3-blade

 

763964  13" pitch Rogue 4-blade

 

763965  15" pitch Rogue 4-blade

 

 

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Mate
Posts: 1
Registered: ‎06-08-2019

Re: Engine sound

Have a 2011 e-tech 115 first issue trim switch is faulty got stuck in the go down position and ran the battery down. Replaced the battery using old one as a spare, lowered motor. Didnt act up, started and idled well, headed out on the lake. Throtthed up to on plane and the motor sputtered then a solid warning beeeeep came on and the motor stalked and wouldnt start up again. Any idea what failed?
Highlighted
Admiral
Posts: 8,402
Registered: ‎07-14-2011

Re: Engine sound

If the warning horn sounded, what indicator light came on ?

If it was the CHECK ENGINE light, the first thing to investigate is water in the fuel system.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.