Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 1
Registered: a month ago

Evinrude 30 Throttle Cable

Hey Guys I have a 30 evinrude, believe it is a 1993. The throttle box gave out on me last week (gear Stripped). I was able to get a replacement box from a local shop for free but the cables are about 3-4 feet too long. I was wondering if anyone had any advice on shortening the cable or if I could swap my cables out from my old box and how hard this is? Thanks

Highlighted
Admiral
Posts: 8,391
Registered: ‎07-14-2011

Re: Evinrude 30 Throttle Cable

Having cables too long can affect the shift and throttle action due to increased free play when the excess is coiled up.

 

If both control boxes are 1978 or later, then you can transfer the cables from one to the other.

Be sure to grease everything that slides, rotates, or moves and take care during disassembly and reassembly. Take pictures with your phone for reference.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.