Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Mate
Posts: 4
Registered: ‎08-05-2019

Help finding Motor Data Port

I have a 2013 E-tec 115 (E115DSLABA)

 

I have built my NMEA backbone and drop system from my Lowrance, but cannot seem to find the connector to connect it. The only connector I have found so far is on the port side of the engine near the fuel filter. But looking at engine diagrams (that are minimal) That connector seems to go to an exhaust valve control relay.

 

Can someone point me in the right direction for the NMEA engine data connection point ?

Highlighted
Admiral
Posts: 8,574
Registered: ‎07-14-2011

Re: Help finding Motor Data Port

 

 

 

E-TEC V4  90-115-130  NMEA connector location.jpg

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Highlighted
Mate
Posts: 4
Registered: ‎08-05-2019

Re: Help finding Motor Data Port

Thank you Bill, that's what I needed.