Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Skipper
Posts: 7
Registered: ‎02-24-2013

ICON PRO gauges

I recently took advantage of the re-power promotion and will be replacing my tired and thirsty 1988 225 with a 200HO.  The dealer will be installing the new ICON PRO 3.5in RPM and Speedometer as well as the 2in ICON Fuel, Volt, Water Pressure and Water Temp. Gauges.  Question 1 - trying to decide white or black?  I like the white for daytime viewing while the ICON brochure only shows the nighttime black with red numbers (looks ideal for night).  How do the white gauges appear at night?  Question 2 - I will be doing a new gauge panel and need to know the hole size for the 3.5 and 2 in. Gauges and minimum spacing center to center between the RPM and Speedometer holes to give 1/2 inch between the two gauges.  Thanks Rich

Highlighted
Admiral
Posts: 8,812
Registered: ‎07-14-2011

Re: ICON PRO gauges

 

 

The following is from the installation manual:

 

Minimum Gauge Spacing (center to center)

 

• 5 3/8 in. (144 mm) between 5 in. instruments

 

• 4 1/8 in. (105 mm) between 5 in. instruments and 2 in. instruments

 

• 3 15/16 in. (100 mm) between 3.5 in. instruments

 

• 3 1/4 in. (83 mm) between 3.5 in. instruments and 2 in. instruments

 

• 2 3/4 in. (70 mm) between 2 in. instruments

 

Instrument Panel Thickness -- One inch (26 mm) maximum.

 

Hole Sizes

 

• 4 3/8 in. (111 mm) for 5 in. instruments

 

• 3 3/8 in. (86 mm) for 3.5 in. instruments

 

• 2 1/16 in. (53 mm) for 2 in. instruments

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.