11-27-2012 06:27
I purchased my 90hp before this season and was told by my E-Tec dealer that it was a good idea to change the lower gearcase lube every year. I have about 50 hours on the engine now. I know the manual shows three years for first service, would you suggest changing the lubricant, prior to that 3 year (300) first service? If so, what lube do they suggest an owner use for the E-Tec? Is there a web site that shows this procedure?
11-28-2012 07:27
The Evinrude HPF Pro gear lube is recommended for all E-TEC models.
It is one of the best marine gear lubes available today.
It's up to you whether or not you change the lube every year, but it is not needed until the 3 year or 300 hour mark, which ever comes first. At the very least, you should remove the propeller and make sure no fishing line has gotten caught and wrapped around the prop-shaft. This would damage the seal and cause an oil leak. If you were to find fishing line around the prop-shaft, then it would be advisable to check/change the gear lube to ensure water has not entered the gearcase.
Regarding the oil change procedure, we are in the middle of filming a video for this. If you're not in a rush to change the gear lube, we will post the video on this site in the near future.
Hope this helps,
-John
11-28-2012 11:03
Thank You John for your reply!
I will wait until the video post shows up on this site. Appreciate your thoughts.
12-07-2012 03:39
OconeeRich,
The video has been posted. Click the link below.
Hope this helps you!
-John
12-16-2012 03:34
John,
Thanks so much for the Video it was very helpful.
OconeeRich
04-25-2014 07:21
how much lube in ounces for 90 hp 2011 lower end?
04-25-2014 07:24
The volume of oil varies with the model number. what is the engine model number?
"There is never just one thing wrong with a boat";
-- Travis McGee, main character in a book series by John D. McDonald
***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.
The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.
04-25-2014 07:54
04-25-2014 09:42
31.6 oz. of Evinrude HPF-Pro lower unit oil
"There is never just one thing wrong with a boat";
-- Travis McGee, main character in a book series by John D. McDonald
***************
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.
The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.
04-26-2014 12:09