Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Captain
Posts: 89
Registered: ‎08-29-2018

Mag2

The seals are leaking in the lower unit and I can’t get the bearing carrier out on the mag 2 .have heated and the top part seems loose but no come out
Highlighted
Admiral
Posts: 9,182
Registered: ‎07-14-2011

Re: Mag2

Mag II gearcase requires special tools and a press to both remove and install rear bearing carrier. See your dealer. Perhaps he has the speciall tool for removing and installing seals without needing to remove the carrier which would save you some money.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.