Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Posts: 1
Registered: ‎02-19-2013

Need help locating cable to convert 1986 6 hp from tiller to control box on throttle

Does anyone know where to get the correct cable to go from the control box to the inside connections of  a 1986 6 hp? Everyone want to sell me one that is designed to connect outside and this model has no outside connector. Is the a device that connects the 2 cables together? Any help will be greatly appreciated.

Posts: 9,367
Registered: ‎07-14-2011

Re: Need help locating cable to convert 1986 6 hp from tiller to control box on throttle

To use remote controls onyour 6hp motor, you need to install the # 431840 kit for the throttle hookup.




"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 



The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.