Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Mate
Posts: 4
Registered: ‎02-09-2019
Accepted Solution

OMC Diagnostic software 1.41

I bought this from OMC to use with my 1999 200 Evinrude. Can I use it to check my E40DSLIIA 2011. Just want to confirm hours on motor. Just bought it used. Looks like same connection.
Highlighted
Admiral
Posts: 7,595
Registered: ‎07-14-2011

Re: OMC Diagnostic software 1.41

It will not work with an E-TEC engine. That was the original DOS based software for the early model FICHT outboards and was very limited in what it could do.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Mate
Posts: 4
Registered: ‎02-09-2019

Re: OMC Diagnostic software 1.41

Cool, figured I’d check before I just tried it. Guess I’ll be buying the new software and cable.