Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Skipper
Posts: 19
Registered: ‎10-18-2016

Propeller zinc anodes on G2'S

Today wentl boating with my twin Evinrude 200 ho G2's, I noticed when I came out of the water my anodes inside the propellers are missing along with the little 10 millimeter bolt that holds them in place. Obviously I need to order new, is that a warranty issue? what is the part number and the approximate cost?
Admiral
Posts: 8,423
Registered: ‎07-14-2011

Re: Propeller zinc anodes on G2'S

[ Edited ]

 

 

 

Not nomally a factory warranty issue but check with your dealer to see if you have the latest style anode.

 

Installing the anode and tightening the bolt is the usually resposibility of the person who put the prop on last.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Skipper
Posts: 19
Registered: ‎10-18-2016

Re: Propeller zinc anodes on G2'S

Thanks what's the part number?
Highlighted
Admiral
Posts: 8,423
Registered: ‎07-14-2011

Re: Propeller zinc anodes on G2'S

 

Install the anode and screw on the propeller shaft.
Tighten the screw to 177 to 204 in. lbs. 

 

http://shop2.evinrude.com/ --  for online parts ordering from Evinrude.  Use engine model number 

 

5009220  -  propshaft anode and screw  --  $18.99

 

 

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.