Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Skipper
Posts: 3
Registered: ‎10-12-2012

STICKERS

What is the best way to remove the Canadian & EU stickers from my 2012  150 without damage?

 

Admiral
Posts: 8,506
Registered: ‎07-14-2011

Re: STICKERS

 

 

I have heard that softening them with a hair dryer helps to make removal easier. GooGone will clean up any adhesive residue.

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Highlighted
Skipper
Posts: 5
Registered: ‎02-21-2013

Re: STICKERS

Softening them with heat is the way to go. WD40 will also remove the adhesive without any worries about the paint.