Evinrude E-NATION, for those dedicated to water, power, fishing and fun
Reply
Highlighted
Skipper
Posts: 5
Registered: ‎07-01-2014

center pod/transom

Looking into putting a 10'  to 15' center pod/transom on my 24' pontoon, I just replaced my 19" tubes with 25" tubes, what diameter pod should I use for the center pod?My old transom just can't handle the weight of my 115 v4 e-tech,also I can't get the motor  low enough into the water. I installed a jack plate on my old stlye transom, and moving the motor back the 6" is tweeking out the back of my boat.

Highlighted
Admiral
Posts: 8,571
Registered: ‎07-14-2011

Re: center pod/transom

I believe that you would get a better answer from the manufacturer of your pontoon boat.,

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.


Highlighted
Skipper
Posts: 5
Registered: ‎07-01-2014

Re: center pod/transom

ok it's an early 80s model aquapatio that I totally restored from the ground up.. I didn't add the motor until after I got done, then didn't change the tubes until after that. One thing leading to another. Wasn't sure how to get hold of the manufacture. Do you have any idea where I could get a center pod? I kive in Ohio 30 min. west of Cleveland, right on lake Erie.

Highlighted
Admiral
Posts: 8,571
Registered: ‎07-14-2011

Re: center pod/transom

 

 

http://www.aquapatioboats.com/

 

 

 


"There is never just one thing wrong with a boat";
                    -- Travis McGee, main character in a book series by John D. McDonald 


 



***************

The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.

The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.