After running the E-TEC 15HO as a "kicker motor" on my Ranger 620 VS - I would like to offer the following review:
I have never owned a "kicker motor" that has been as reliable or as consistent as the E-TEC 15HO!
It starts immediately, even after sitting for over a month without being run. While others contestants that don't run E-TEC are warming up their kickers in the morning before take-off for the tournaments, I am tying lines or focusing on the tournament ahead, knowing that my E-TEC will start, run and troll immediately.
Minor speed adjustments are vital to trolling success and the E-TEC 15HO has a button that allows for RPM adjustments up or down of 50RPM - which equates to @ a tenth of a mile per hour. Perfect for trolling success.
A long and centered tiller handle means you can place the E-TEC 15HO on either the starboard or port side of the boat. With the Tilt-n-Trim switch on the end of the tiller handle, quickly and easily found, trimming the engine is a breeze.
Also a beautifully matched set sitting next to my E-TEC 250HO
If you own a small boat - the 15HO would be a great choice, with lots of thrust and reliability.
Thank you for the review and for being one of the evergrowing members of the Evinrude family.
"There is never just one thing wrong with a boat";
-- Travis McGee, main character in a book series by John D. McDonald
The factory recommends that a properly trained technician service your Johnson or Evinrude outboard motor. Should you elect to perform repairs yourself, use caution, common sense, and observe safety procedures in the vicinity of flammable liquids, around moving parts, near high-temperature components, and working with electrical or ignition systems.
The information offered here is only general in nature and should not be construed as complete factory approved procedures, techniques, or specifications. Always use the proper service manual for your motor, up-to-date service literature, the correct tools, and have an understanding of how to proceed with troubleshooting and repair methods. If you are unsure or uncomfortable with a procedure, a situation, or a technique, enlist the services of a factory trained technician.